Protecting Your Gear Spanners

Posted by Stephen Weaver on


Gear Spanner Servicing

To service or repair a Gear Spanner that is jammed or  slipping, soak the spanner in CRC Brake Clean for a couple of hours to clean the seized spanners and to loosen debris and fine dirt particles that have clogged up the spanners.

When they come out of the CRC Brake Clean, give them a shake up and a blow out with compressed air. Repeat this step as required until all traces of dirt are removed. Once clean, soak them in CRC Marine for a couple of minutes as it has more of an oil residue to lubricate the spanner then wipe down and test.



Share this post



← Older Post


Leave a comment

Please note, comments must be approved before they are published.